Please see Getting started with Scoppy and the Pico W. To try connecting via USB again the Pico W will need to be restarted. Please note that if you are using a Pico W and a connection over USB hasn’t been established within 10 seconds the Pico W will start listening to connections over Wi-Fi. This status is displayed at the top right of the grid). You may need to tap the ‘Run’ button in the app if the scope is currently stopped (Scoppy will either be RUNNING or STOPPED. Once you open the app and a connection is established between the Pico and the Scoppy app the onboard LED should stop blinking. You should see the status LED on the Pico start blinking.

Then use a USB cable to connect the OTG cable/adapter to the Pico (or Pico W). USBĪttach the small end of the OTG cable/adapter to the USB input of the Android device (do NOT plug it into the USB socket of the Pico!). Connect the Pico or Pico W to your Phone/TabletĬommunication between the firmware on the Pico (or Pico W) and app on the phone/tablet can be either via USB or Wi-Fi (Pico W only). Release BOOTSEL once the drive RPI-RP2 appears on your computer. You computer should detect the Pico as a USB Mass Storage device. Push and hold the BOOTSEL button on the Pico, then connect it to your computer using a normal USB cable (Type-A male to Micro-USB male). Scoppy-fscope-500k-picow-v15.uf2 firmware file. If you have an FHDM DSO-500K oscilloscope then you will need to use the

If you have an FHDM FSCOPE board then you will need to use one of these:įSCOPE with Pico: scoppy-fscope-500k-pico-v15.uf2įSCOPE with Pico W: scoppy-fscope-500k-picow-v15.uf2 The Pico firmware is not compatible with the Pico W and vice versa.ĭownload the firmware by selecting one of the following links. Download the Firmwareĭifferent firmware is available for the Pico and Pico W. Install the Scoppy Android app from the Play Store.

Pi pico pinout download